Accessories and attachments, Tools needed for assembly – Craftsman 137.212290 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ACCESSORIES AND ATTACHMENTS

TOOLS NEEDED FOR ASSEMBLY

RECOMMENDED ACCESSORIES

A WARNING

• Use only accessories recommended for this

miter saw. Follow instructions that accompany
accessories. Use of improper accessories may
cause hazards.

• The use of any cutting too! except 10 inch saw

blades which meet the requirements under
recommended accessories is prohibited. Do
not use accessories such as shaper cutters or
dado sets. Ferrous metal cutting and the use of
abrasive wheels is prohibited.

• Do not attempt to modify this tool or create

accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result In a hazardous condition
leading to possible serious Injury.

ACCESSORIES

Visit your Sears Hardware Department or see the
Sears Power and Hand Tool Catalog to purchase

recommended accessories for this power tool.

A WARNING

To avoid the risk of persona! injury, do not
modify this power tool or use accessories not
recommended by Sears.

A WARNING

Read warnings and conditions on your CARBIDE

TIPPED SAW BLADE. Do not operate the saw
without the proper saw blade guard in place.
Carbide is a very hard but brittle material. Care
should be taken while mounting, using, and storing
carbide tipped blades to prevent accidental damage.
Slight shocks, such as striking the tip while
handling, can seriously damage the blade. Foreign
objects in the workpiece, such as wire or nails, can
also cause tips to crack or break off. Before using,
always visually examine the blade and tips for bent
blade, cracks, breakage, missing or loose tips, or
other damage. Do not use if damage is suspected.

Failure to heed safety instructions and warnings can
result in serious bodily injury.

Blade Wrench (supplied)

Philips Screwdriver

Adjustable Wrench

Hex Key 2.5 mm

Combination Square

COMBINATION SQUARE MUST BE TRUE

straight edge or
a 3/4 in. board,

Draw light line on board

along this edge.

perfectly straight.

Should not gap or overlap when
square is flipped over (see
dotted figure).