Craftsman 315.269210 - Manual (Page 10)

ADJUSTMENTS
ADJUSTING DEPTH OF CUT
See Figures 3, 4, 5, and 6.
We recommend that cuts be made at a depth not
exceeding 1/8 in. and that several passes be made to
reach depths of cut greater than 1/8 in.
■ Unplug your router.
A WARNING: Failure to unplug your router could
■*“ result in accidental starting causing serious
injury.
■ Place router on a flat surface and loosen locking
arm.
See Figure 3.
LOCKING
ARM
Fig.3
Turn depth adjusting ring until cutter is inside
subbase.
See Figure 4.
Turn depth adjusting ring until tip of cutter touches
flat surface.
TO
LOWER
CUTTER
TO RAISE
CUTTER
INDICATOR
POINT
CUTTER
INSIDE SUBBASE
DEPTH
, ADJUSTING
0/ RING
DEPTH
INDICATOR
RING
Turn the depth indicator ring until the zero lines up
with the indicator point on the base.
See Figure 5.
DEPTH OF CUT Fig. 5
Position router so that the cutter can extend below
the subbase for desired depth setting.
See
Figure 6.
BELOW SUBBASE Fig. 6
SUBBASE Fig. 4
Turn the depth adjusting ring to obtain the desired
depth of cut. The distance the cutter moves can be
read on the depth adjusting ring. Each mark on the
depth adjusting ring indicates 1/32 inch change in
depth setting. Indicator point is located on the
base.
Tighten locking arm securely.
10