Craftsman 917.270962 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING CHART
PROBLEM
Loss of power
{Continued)
Excessive
vibration
Engine continues
to run when
operator leaves
seat with
attachment
clutch engaged
Poor cut - uneven
Mower blades will
not rotate
CAUSE
Build-up of grass, leaves
and trash under mower.
Dirty air filter.
Low oil level/dirty oil.
Faulty spark plug.
Dirty fuel filter.
Stale or dirty fuel.
Water in fuel.
• Spark plug wire loose.
• Dirty engine air screen/fins.
• Dirty/ciogged muffler.
• Loose or damaged wiring.
• Carburetor out of
adjustment.
• Engine valves out of
adjustment.
CORRECTION
• Worn, bent or loose blade.
• Bent blade mandrel.
• Loose/damaged part(s).
Faulty operator-safety
presence control system.
Worn, bent or loose blade.
Mower deck not level.
Buildup of grass, leaves,
and trash under mower.
Bent blade mandrel.
Clogged mower deck vent
from build-up of grass,
leaves, and trash around
mandrels.
• Obstruction in clutch
mechanism.
• Worn/damaged mower
drive belt.
• Frozen idler pulley.
• Frozen blade mandrel.
• Clean underside of mower
housing.
• Clean/replace air filter.
• Check oil levei/change oil.
• Clean and regap or change
spark plug.
• Replace fuel filter.
• Drain fuel tank and refill with
fresh gasoline.
• Drain fuel tank and carbure
tor, refill tank with fresh
gasoline and replace fuel
filter.
• Connect and tighten spark
plug wire.
• Clean engine air screen/
fins.
• Clean/replace muffler.
• Check ail wiring.
• See ‘To Adjust Carburetor”
in Service Adjustments
section.
• Contact an authorized
service center/department.
• Replace blade.
Tighten blade bolt.
• Replace blade mandrel.
• Tighten loose partfs).
Replace damaged parts.
' Check wiring, switches and
connections, if not corrected,
contact an authorized
service center/department.
• Replace blade. Tighten
blade bolt.
• Level mower deck.
• Clean underside of mower
housing.
• Replace blade mandrel.
• Clean around mandrels to
open vent holes.
• Remove obstruction.
• Replace mower drive belt.
• Replace idler pulley.
• Replace blade mandrel.
31