CNet Technology CNIG904S - Manual (Page 7)

CNet Technology Inc
4
Physical Details
Please take a few minutes to familiarize yourself with the Broadband Router.
Top - Mounted LEDs
There are 2 LEDs on the top of the unit. The "DATA STATUS LAN" LED has 2 colors -
Green and Orange. Operation of these LEDs is as follows:
DATA STATUS LAN
(Green/Orange) On (Green) - Normal start up/power on sequence, or idle.
The Data/Status LED will flash under the following conditions:
• Flashing (Green) – The Data/Status LED will flash when
data is transmitted or received through the LAN ports.
• Flashing (Orange, Green, Orange,…) – Hardware error.
Contact your dealer for technical support.
DATA WAN
(Green) On - Normal start up (power ON) sequence or idle.
Flashing – The Data LED will flash when data is transmitted or
received through the WAN port.
Rear Panel
Reset
button 10/100 BaseT
LAN Connectors Power
Input
WAN
Uplink
RESET
WAN
port DIP
switches
LAN Port
LEDS
4 3 2 1
WAN port
LED
1 2 3 4
Link/
Act
100
LAN
Uplink
port
Figure 2: Rear Panel
DIP switches Refer to the following table for DIP switch operation.
LAN Port LEDs
- Link/Act On - The Router is successfully connected to a device through the
corresponding port (1, 2, 3, or 4).
Flashing - Transmitting or receiving data over that port.
LAN Port LEDs
- 100 On - LAN port connection is using a 100BaseT connection.
Off - Port is unused or using 10BaseT connection.
10/100BaseT
LAN Connectors Use standard LAN cables (RJ45 connectors) to connect your PCs ot
these ports. Both 10BaseT and 100BaseT connections can be used
simultaneously.
If Port 4 is used, the "Uplink" port can NOT be used..
Uplink Port Use the "Uplink" port ONLY to connect (via a normal LAN cable)
to a normal port on another hub.
If the "Uplink" port is used, Port 4 can NOT be used.