A danger, I do not operate this machine – Craftsman 247.776360 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sears Craftsman 7.5 HP Chipper Shredder Model 247.776360
777S32604
AWARNING
Do NOT E>laoo l^ranohes over 1/2 inch
diameter
into
the
large
Shredder
Hot>|ier. Branches over 1/2 inch In
diameter should be placed in the
Small Chipper Chute.
Material feed into hopper
should
be
metered
as
instructed
in
operator's
manual te avoid clogging.
Read the operator's manual(s) before starting and using unit. '
Keep all shields and guards In place and securely attached.
Keep hands, teat, face, clothing and long hair out of Shredder
Hopper, Chipper Chute and Discharge Chute while the engine is
running. Rotating cutting blades Inside these openings will cause
serious personal injury if contacted. Material being processed ,
may bounce back from Inlet openings or be thrown from the .
discharge chute. Long hair or loose clothing may be pulled
or sucked into the Inlet openings.
If the chipper shredder jams or becomes clogged, refer to
operator's manual on clearing a blockage.
*
If engine stalls because of jam, move throttle control lever to
atop position or shut-off rocker switch to *0’ OFF if equipped,
before clearing.
Do not Install remove, adjust, or service the discharge screen or
any other part while the engine is running. Blade contact can
occur.
Do not operate on uneven ground where unit Is unstable.
Do not operate with Chipper Chute In up position if equipped.
Latched up is for storage only. Unlatch, lower and lock Chipper
Chute In place before operating machine.
Do net operate on pavement, gravel or other hard surfaces
since objects can ricochet and cause injury.
To avoid a firs hazard, keep leaves, grass, and other
combustible materials away from hot engine and muffler.
Keep children and others away from area of operation.
Wear approved safety glasses, gloves and ear protection.
777D10398
777S32282
A DANGER
I DO NOT OPERATE THIS MACHINE
I UNLESS THE CHUTE DEFLECTOR
^HAS BEEN PROPERLY INSTALLED.
777S30180
• ROTATING CUTTING BLADES. KEEP HANDS
and
FEET OUT OF OPENING WHILE
MACHINE IS RUNNING.
• DO NOT OPERATE THIS MACHINE UNLESS
THE CHUTE DEFLECTOR HAS BEEN
PROPERLY INSTALLED AND IS SECURED
WITH THE HAND KNOBS.
17