Craftsman 919.762700 - Manual (Page 7)

Checklist
Before going any further please review the following:
♦ Be sure you have completed assembly instruction.
• Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your pres­
sure washer be sure to check engine oil (See Operation
under Engine Oil, page 9.)
OPERATION
Know Your High Pressure Washer
Read this Owner^s Manual and Safety Rules before
operation of your High Pressure Washer Compare
this illustration with our pressure washer to familiarize
yourself with the location of various controls and
adjustments. Save this manual for future reference.
PUMP- Develops high pressure.
ENGINE OIL. FILL- Place where engine oil is poured.
PRESSURE REGULATOR- Allows you to adjust the
pressure of the outlet stream.
ENGINE RUN/STOP SWITCH- Sets engine in starting
mode for recoil starter —
Stops running engine.
RECOIL STARTER- Used for starting the engine
manually.
SPRAY GUN ASSEMBLY- Controls the application of
water onto cleaning surface with trigger device.
PUMP OIL FILL- Port where pump oil is poured and
breather cap is located.
GAS TANK/CAP- Cap is removed and unleaded
gasoline is poured.
CHEMICAL INJECTION TUBE AND FILTER- Mixes
water and detergent in outlet water flow.
HIGH PRESSURE OUTLET- Connection for high pres­
sure hose.
CHOKE- Lever used for starting unit.
CHOKE
LEVER
GUN WAND
ASSEMBLY
HANDLE
ON/OFF
PRESSURE
ENGINE OIL REGULATOR
FILL
PUMP OIL
FILL
THROTTLE
1
dB
"^1
W*' i
SU_
CHEMICAL
ADJUSTMENT
KNOB
CHEMICAL INJECTOR
TUBE & FILTER
HIGH PRESSURE
WATER INLET
CONNECTION