Craftsman 919.762700 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Remove wood plank from the frame of the unit.

An adjustable wrench is required. Discard nut,

bolt and board.

3. • Mount the rubber isolator to the frame. To mount

isolator place threaded end of bolt through the
washer. Next with washer on bolt place threaded
end of bolt through the rubber isolator. Place
threaded portion of isolator through the same
hole location the wood plank was mounted to on
the pressure washer Next place lockwasher
over threaded portion of nut that has been
placed through

'Me mounting hole in the pressure

washer and use nut to tighten isolator to the
frame. Tighten nut with an adjustable wrench. All
isolator parts are supplied In parts bag.

NUT

LOCKWASHER

r-C

PRES^RE

W>^HER

FRMIE

^^^ISOLATOfl

BOLT—

Connect wand with nozzle extension to gun. To
tighten, turn knob in clockwise direction. Hand
tighten.

5. • Cut tie wrap off of high pressure hose. Unwind

high pressure hose to attach the threaded end to
the gun.

NOTE: Do not remove Telfon tape on threads.

6. • Connect chemical hose to the chemical injector

nipple on the pump.

7. • Connect high pressure hose to the quick connect

outlet on pressure washer.

QUICK CONNECT

OUTLET

NOTE: Keep hose away from engine muffler.

8. • Place assembled gun and wand on pressure

washer holder.

NOTE: Your unit’s pump is shipped with a

temporary plug that must be replaced with a

breather cap. This plug is located over the pump’s

oil port. Unscrew and remove this plug. Remove
the breather cap from the bag attached to the plug
and install it in the pump’s oil port.

8NEATHER

CAP

A CAUTION; Failure to replace the plug will res

in serious pump damage.