Craftsman 580.747100 - Manual (Page 13)

STORAGE
PRESSURE WASHER PUMP
Water should not remain in the unit for long periods of time.
Sediments of minerals can deposit on pump parts and
“freeze" pump action., If you do not plan to use the Pressure
Washer for more than 30 days, follow this procedure:
» Flush detergent hose by placing the injector filter into
a pail of clear water while running Pressure Washer
with nozzle in low pressure mode. Flush for five min­
utes,
» Shut off the engine and let it cool, then remove all
hoses.
Place throttle lever in “STOP“ position.
A CAUTION: BE SURE THE THROTTLE LEVER IS IN
"STOP" POSITION BEFORE YOU CONTINUE. IF
YOU START THE ENGINE WITHOUT THE PROPER
WATER SUPPLY CONNECTED, YOU CAN DAM­
AGE THE PUMP.
“ Empty the pump of all plumped liquids by pulling recoil
handle about 6 times, This should remove most of the
liquid In the pump.
NOTE: To protect the unit from freezing temperatures, you can draw
windshield washer fluid Into the pump by pouring the washer fluid
Into a 3-foot section of garden hose connected to the inlet adaptor
and pulling the recoil handle twice.
» Store in a clean, dry area.
ENGINE
A
WARNING: NEVER STORE ENGINE WITH FUEL IN
TANK INDOORS OR IN ENCLOSED, POORLY VEN­
TILATED AREAS WHERE FUMES MAY REACH AN
OPEN FLAME, SPARK OR PILOT LIGHT AS ON A
FURNACE, WATER HEATER, CLOTHES DRYER
OR OTHER GAS APPLIANCE.
Drain Fuel System: Remove all gasoline from carburetor
and fuel tank to prevent gum deposits from forming on
these parts and causing possible malfunction of engine.
A
WARNING: DRAIN FUEL INTO APPROVED CON­
TAINER OUTDOORS, AWAY FROM OPEN FLAME.
BE SURE ENGINE IS COOL. DO NOT SMOKE.
“ if you did use "gasohol", run engine until engine stops
from lack of fuel. Make sure you have water supply to
pump inlet connected and turned ON.
» Fuel stabilizer (such as STA-BIL®) is an acceptable
alternative in minimizing fuel gum deposits during stor­
age.
Change Oil: While engine is still warm, drain oil from
crankcase. Refill with recommended grade.
Oil Cylinder Bore: Remove spark plug and pour about 1/2
ounce (15ml) of engine oil into the cylinder. Cover spark
plug hole with rag. Crank slowly to distribute oil.
A CAUTION! AVOID SPRAY FROM SPARK PLUG
HOLE WHEN CRANKING ENGINE SLOWLY.
it is important to prevent gum deposits from forming in
essential fuel system parts such as the carburetor, fuel
filter, fuel hose or tank during storage. Also, experience
indicates that aicohoi-blended fuels (called "gasohor or
using ethanol or methanol) can attract moistu re which leads
to separation and formation of acids during storage. Acidic
gas can damage the fuel system of an engine while in
storage
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer Follow these
instructions:
“ Install spark plug. Do not connect spark plug wire
OTHER
• Do not store gasoline from one season to another,
» Replace your gasoline can if your can starts to rust.
Rust and/or dirt in your gasoline will cause problems.
® If possible, store your unit indoors and cover it to give
protection from dust and dirt.
« Cover you unit with a suitable protective cover that
does not retain moisture. Do not use plastic. Plastic
does not breathe, which allows condensation to form
and will cause your unit to rust
IMPORTANT: N E V E R C O V E R Y O U R P R E S S U R E
WASHER WHILE ENGINE ÂND EXHAUST AREAS ARE
WARM.
13