Craftsman 919.763010 - Manual (Page 5)

IMPORTANT SAFETY INSTRUCTIONS (contad)
HAZARD WHAT CAN HAPPEN HOW TO PREVENT IT
A warning
RISK OF HOT SURFACES
Contact with hot surfaces, such as
engines exhaust components, could
result in serious burn. During operation, touch only the control
surfaces of the pressure washer. Keep
children away from the pressure washer
at all times. They may not be able to
recognize the hazards of this product.
International
Symbols lAlm
Safety Ateft - ftead
Owner’s Manual
o
On Of! Stop
Fuel
Shutoff
Fuel
N
Choke
IMPORTANT:
The powerful spray from your pressure washer is capable of causing damage to fragile surfaces such as: wood, glass,
automobile paint, auto stripping and trim, and delicate objects such as flowers and shrubs. Before spraying, check the
item to be cleaned to assure yourself that it is robust enough to resist damage from the force of the spray. Avoid the
use of the concentrated spray stream except for very strong surfaces like concrete and steel.
Operating unit with water supply shut off without flow of water will result in equipment damage. You should never run
this pressure washer for more than 2 minutes without pulling the trigger to allow cool water to enter the pump and the
heated (recirculated) water to exit. Running the pressure washer with water supply shut off will void your warranty.
ASSEMBLY
Carton Contents
• Main Unit pressure washer with wheels
• Handle
• High Pressure Hose
• Chemical Pickup Hose and Filter
• Bag Containing
Video Cassette
Owners’ Manual
Nozzle Cleaning Kit and Replacement 0-Rings
Rubber Isolator and Mounting Hardware
• Box Containing
Gun
Wand
Engine Oil
Handle Mounting Hardware
Tools Required for Assembly
Adjustable wrench
1/2” Socket wrench
Remove Pressure Washer from Carton
• Open box from the top. Locate and remove from
box, the parts box, which includes gun, handle,
wand, oil, nuts bolts and washers for handle
installation.
• Cut carton along dotted lines.
• Remove all carton inserts.
• Roll unit through opening in carton.
NOTE: The hose is located at the bottom of the box.
Preparing the Pressure Washer for First Use
• Note: included with your pressure washer is a video
tape on how to prepare your unit for operation. It is
recommended you view this tape before performing
the next steps.
1. • Place handle on frame.
• Insert bolts into holes provided in handle.
• Line up handle and bolts with the holes provided
on frame.
• Insert bolts through holes in frame.
• Place washers and over inserted bolts. Next place
nuts over bolts and tighten with adjustable wrench
turning in clockwise direction.
BOLT
2. • Attach chemical basket to the pressure washer
frame opposite side of muffler. Holes are
provided on frame.