Craftsman 486.24628 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(2)

7/16" Wrenches

(2)

9/16" Wrenches

(1)

3/4" Wrench

CAUTION! Muffler is hot! Allow engine to
cool down before proceeding with bumper
installation.

STEP 1:

(SEE FIGURE 1)

•

Slide the ends of the latch into the slots located on
the bottom of the bumper.

•

Push the front of the latch down past plastic shroud

of bumper. Latch will be under the shroud and
should appear as shown in figure 3 when assembled
correctly.

•

Attach one spring onto the rod on each side of the

latch.

STEP 2:

(SEE FIGURE 2)

•

Insert 1/4

1-1/4" hex bolt through one of the springs.

•

Assemble 1/4 x 1-1/4" hex bolt onto the bumper using
two 1/4-20 hex nuts (SIMS) with end of bolt extending
slightly through outside nut.

•

Repeat for spring on other side.

STEP 3:

(SEE FIGURE 3)

• Assemble a 3/8 x 1" hex bolt, 3/8" washer, frame

brace and 3/8" lock nut to the rear hole of the bumper.

Call 1 -866-576-8388 for missing parts or assembly help

DO NOT RETURN TO STORE