Craftsman 580.767451 - Manual (Page 8)

2. Remove and discard shipping caps from pump iniet
and outlet.
3. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
4. Before connecting garden hose to water inlets
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. Refer to
section “0~Ring Maintenance” if inlet screen is
damaged.
DO NOT run pressure washer if iniet
screen is damaged.
5. Run water through garden hose for 30 seconds to
flush it of debris. Turn off water.
IMPORTANT; DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
6. Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
CAUTION
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any flow
shut off device, such as a *Y' shut-off connector or
other convenience-iype water shut-off valve.
Damage to equipment; resulting from failure tO; follow
this instruction will void warranty................................
7. Turn ON water and squeeze trigger on spray gun
to purge pump system of air and impurities.
A
WARNING
High pressure spray can cause paint chips
or other particles to become airborne.
Always wear eye protection when using! this equipment
or in vicinity of where equipment is in use.! tit
Before; starting the pressure washer, ;be sure you; i
wearing! adequate eye protection,.................
are
CHECKLIST BEFORE STARTING
ENGINE
Review the unit to ensure you have performed all of
the following:
1, Check that hose reel fasteners are tight.
2, Check that oil has bean added to proper level in
engine crankcase.
3, Add proper fuel to fuel tank.
4, Check for proper hose connections {high pressure
and water supply) and that there are no kinks,
cuts, or damage to the high pressure hose,
5, Provide proper water supply (not to exceed
100=F).
0, Be sure to read “Safety Rules” and “Operation”
sections before using the cleaning system.