Assembly, Remove pressure washer from carton, Carton contents – Craftsman 580.767451 User Manual
Page 6: Assembling cleaning system, Assembling hose reel
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Your cleaning system requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel
If you have any problems with the assembly of
your pressure v^^sher, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
1. Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
2
.
3,
5.
Remove hose reel box, fillers, and parts bag
shipped with cleaning system.
Remove spray gun, nozzle extension, and engine
oil from fillers.
Roil cleaning system out open end of carton.
Raise guide handle, secure in place.
;ift handle to
and slide locking caps
^ Y : place
0, Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136,
• Main unit — cleaning system with wheels, chemical
tanks, guide handle
• Hose reel components
• High pressure hose
• Spray gun
• Nozzle extension with adjustable nozzle
• Engine oil
• Parts bag (which includes items listed below)
Three-pack of chemical concentrates
Owner’s manual
Maintenance kit
Tank labels
Registration card
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 5, If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly
before operation:
1. Attach hose reel.
2. Add oil to engine crankcase,
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and pump.
5. Connect water supply to pump.
Assembling Hose Reel
Obtain 14mm and 10mm open end wrenches and a #2
Phillips
screwdriver.
1. Attach handle to reel with locknuts, flalwashers,
and bolts as shown.
2. Secure hose reel to left side upright with locknuts
and bolts.