Clarity Professional XLC2 - Manual (Page 10)

16 17
E
N
G
L
I
S
H
HANDSET
The batteries in the handset must be fully charged for 10
hours before using the telephone for the first time.
Battery life: Talk time is 6.5 hours, while standby is 130
hours without usage. Actual times will vary depending on the
amplifier settings used. Replace batteries every two years.
Battery spec (as supplied with your phone): 3xAAA NiMH
rechargeable batteries, (1.2V 600mAh NiMH, 60AAAHC, GPI
International Ltd.).
To replace batteries, remove the handset battery cover and
install new batteries, then close battery cover.
BASE (OPTIONAL)
The base batteries are optional (backup). You should use
3xAAA NiMH rechargeable batteries if you choose to put
them in the base. The backup batteries should be AAA, NiMH,
rechargeable only, rated 600mAh.
The base backup batteries ensure the functionality of your
cordless phone (3-4 hours), in case of a power outage.
The batteries in the base must be fully charged for 10 hours.
When the base unit operates in battery mode (no AC power).
the base POWER light will blink once every two seconds.
To install batteries in the base:
1. Turn base over and remove memory card.
10. TALK: Press TALK to start an outgoing phone call or to
answer an incoming call. Also, press TALK when the handset
is found (if the FIND function is activated from the base).The
TALK button lights up as per the settings below:
• green when the phone is in use, non-Boost mode;
• red when the BOOST function is engaged;
• orange when the OSA function is active;
• blinks green during incoming ring or when the base is
paging the handset (FIND function is engaged) - along with
the visual ringer;
• blinks green (slower) during the memory programming
process.
11. Dial Pad: Used to dial the phone numbers. The keys also
serve as the location for 10 two-touch memory locations (see
details under PROGRAMMING / DIALING MEMORY KEYS
section - page 20). The dial pad is backlit for ease of use.
12. RD / P (Redial / Pause): When you hear the dial tone,
press this button to redial the last number dialed (up to 32
digits). Press this button while programming the memory keys
to insert a two second pause.
13. TONE Switch: Use this switch to pick one of the three
tone settings available (see page 21).
14. NECKLOOP Port: Use a standard 3.5mm neckloop
with your XLC2 handset. We recommend the Clarity CE30
Neckloop.
15. Headset Port: Use a standard 2.5mm plug headset with
your XLC2 handset. We recommend the Plantronics M175C.
16. RINGER ON / OFF: Set this switch to OFF position if
you want to turn off the handset ringer.
Feature List & Overview -
Handset
XLC2 Battery Information XLC2