Sony TC-WE825S - Manual (Page 5)

Playing a Tape
3 2
• See page 4 for hookup
information.
• You can use either deck for
playback.
To adjust the pitch (Pitch
Control function)
(TC-WE825S/WE725 only)
CONTROL button to activate
Pitch Control function and
turn the control clockwise to
raise the pitch or counter­
clockwise to lower it.
You can adjust the pitch
during playback on deck A or
normal-speed dubbing (but
not during RMS play or RMS
dubbing).
'Q* To play a tape recorded
with the Dolby NR*
system
Set DOLBY NR to ON and
select the same position that
the tape was recorded in—B,
C, or S (TC-WE825S only).
y You can connect the
headphones to PHONES
Dolby noise reduction
manufactured under license
from Dolby Laboratories
Licensing Corporation.
"DOLBY" and the double-D
symbol □□ are trademarks of
Dolby Laboratories Licensing
Corporation.
1 Turn on the amplifier and select the tape deck position.
Press \/(b (or ©), and then press =
and insert a cassette.
With the side you want to play
facing you
Set DIRECTION MODE.
To play back Set to
One side only
Both sides continuously*
Both decks in succession* RELAY
* The deck automatically stops after playing back five times.
Press O.
The deck starts playing. Adjust the volume on the amplifier.
Do not press
\/(b
(or ©) or = while the tape deck is
operating. If you do so, the tape may be damaged.
To Press
Stop playing ■
Start playback from the reverse side
Pause PAUSE II. Press the button again to
resume play.
Fast-forward or rewind ► ► or when the deck is stopped
Increase the tape fast-forward or
rewind speed (High-Speed Fast-
Forwarding and Rewinding
functions) (TC-WE825S/WE725
only) ► ► or ◄ ◄ again during fast-forwarding
or rewinding
Take out the cassette = after stopping playing