Sony CPD-1304C - Manual (Page 3)

Precautions
On safety
• Operate the unit only on 120V AC, 60 Hz.
• Should any liquid or solid object fall into the cabinet, unplug the unit
and have it checked by qualified personnel before operating it any
further.
• Unplug the unit from the wall outlet if it is not to be used for several
days.
• To disconnect the AC power cord, pull it out by the plug. Never pull
the cord itself.
On installation
• Allow adequate air circulation to prevent internal heat build-up.
Do not place the unit on surfaces (rugs, blankets, etc.) or near materi­
als (curtains, draperies) that may block the ventilation holes.
• Do not install the unit in a location near heat sources such as radia­
tors or air ducts, or in a place subject to direct sunlight, excessive
dust, mechanical vibration or shock.
On cleaning
To keep the unit looking brand-new, periodically clean it with a soft
cloth. Stubborn stains may be removed with a cloth lightly dampened
with a mild detergent solution. Never use strong solvents such as thin­
ner or benzine, or abrasive cleansers since these will damage the
cabinet. As a safety precaution, unplug the unit before cleaning it.
On repacking
Do not throw away the carton and packing materials. They make an
ideal container in which to transport the unit. When shipping the unit to
another location, repack it as illustrated on the carton.
If you have any questions about this unit, contact your authorized Sony
dealer.
4
Location and Function of Controls
Front Rear
Sd] Q]
POWER switch and indicator
To turn on the power of the unit, press this switch. The indicator
will light up. To turn off the unit, press it again.
[U CONTRAST control O)
Turn clockwise to increase contrast, or counterclockwise for less
contrast.
BRIGHTNESS control (Q )
Turn clockwise for a brighter display, or turn counterclockwise for a
darker display.
4] AC IN connector
Connect to the AC outlet with the supplied AC power cord
RGB IN (input) connector (9-pin D-sub)
Allows a microcomputer having analog
nected.
Refer to page 7.
RGB output to be con-
5