Chamberlain 3800PLD - Manual (Page 31)

31
NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
One Button Close:
The garage door opener can be closed by pressing only the ENTER button if the one
button close feature has been activated. This feature has been activated at the factory.
To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds. The
keypad will blink twice when the one button close is active. The keypad will blink four
times when one button close is deactivated.
Programming
To Add, Reprogram or Change a Keyless Entry PIN
USING THE “LEARN” BUTTON
Press and release the purple “learn” button on garage door opener. The learn
indicator light will glow steadily for 30 seconds.
Within 30 seconds, enter a four digit personal identifi cation number (PIN) of your
choice on the keypad. Then press and hold the ENTER button.
Release the button when the remote light blinks. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
To change an existing, known PIN
If the existing PIN is known, it may be
changed by one person without using a
ladder.
1. Press the four buttons for the present
PIN, then press and hold the # button.
The garage door opener light will blink
twice. Release the # button.
2. Press the new 4-digit PIN you have
chosen, then press ENTER.
The garage door opener lights will blink
once when the PIN has been learned.
Test by pressing the new PIN, then press
ENTER. The door should move.
To set a temporary PIN
You may authorize access by visitors or
service people with a temporary 4-digit PIN.
After a programmed number of hours or
number of accesses, this temporary PIN
expires and will no longer open the door. It
can be used to close the door even after it
has expired. To set a temporary PIN:
1. Press the four buttons for your personal
entry PIN (not the last temporary PIN),
then press and hold the
✽ button.
The remote light will blink three times.
Release the button.
2. Press the temporary 4-digit PIN you have
chosen, then press ENTER.
The garage door opener light will blink
four times.
3. To set the number of hours this
temporary PIN will work, press the
number of hours (up to 255),
then press
✽.
OR
3. To set the number of times this
temporary PIN will open door, press the
number of times (up to 255), then
press #.
The remote light will blink once when the
temporary PIN has been learned.
Test by pressing the four buttons for the
temporary PIN, then press ENTER. The
door should move. If the temporary PIN
was set to a certain number of openings,
remember that the test has used up one
opening. To clear the temporary password,
repeat steps 1-3, setting the number of
hours or times to 0 in step 3.
USING THE DOOR CONTROL
Press the Prog button on the door control.
Press the Prog button again to confi rm Learn Mode.
Enter a four digit personal identifi cation number (PIN) of your choice on the keypad.
Then press ENTER.
When the remote light blinks, it has learned the code. If light bulbs are not installed,
two clicks will be heard.
1
2
3
4
1
2
3
1
2
3
1
2
3
4