Sony KV-32V26 - Manual (Page 7)

Cable or antenna
Most simple connection. Connection is made
directly from the cable or antenna to the TV.
Cable
(Rear of TV)
VHF/UHF
Cable and antenna
• KV-27S36, 27V36, 29V36C, 29V76M, 32S36, 32V36,
34V36C 35S36,35V36, 35V76, 37V36M only
You may find it convenient to use the
following set up if your cable provider does
not feature local channels that you are able to
receive using an antenna.
(Rear of TV)
AUX
1=333 .....iC®
CATV cable
(No connection "TO
CONVERTER" in this case)
Antenna cable
TO CONVERTER
:3n
VHF/UHF
Select Cable or ANT mode by pressing ANT on
the remote control.
Connecting a cable box
Some pay cable TV systems use scrambled or
encoded signals that require a cable box* to
view all channels.
Cable
(Rear of TV)
VHF/UHF
IN OUT
*Cable box
Note:
• If you will be controlling all channel
selection through your cable box you
should consider using the CHANNEL FIX
feature discussed on page 22.
Cable box and cable
• KV-27S36, 27V36, 29V36C, 29V76M, 32S36, 32V36,
34V36C, 35S36, 35V36, 35V76, 37V36M only
Some pay cable TV systems use scrambled or
encoded signals requiring a cable box* only for
certain channels (e.g. HBO, SHOWTIME, etc.).
*Cable box
scrambled
channels
(Rear of TV)
AUX
TO CONVERTER
=P=CX)— h €J)
I 1
75-ohm coaxial ;
cable (not supplied) \ (signal)
CATV cable
(unscrambled channnels)
VHF/UHF
For this set up, you can switch between scrambled
channels (through your cable box), and normal
(CATV) channels by pressing ANT on your
remote control.
• Your Sony remote control can be programmed
to operate your cable box (see page 26).
Notes:
• You cannot watch the signal through the
"AUX" input as a window picture when
using Picture-in-Picture (PIP).
• If you are connecting a cable box through
the" AUX" input and would like to switch
between the "AUX" and normal (CATV) input
you should consider using the CHANNEL FIX
feature discussed on page 22.