Sony SRF-88 - Manual (Page 7)

using the Arm Band
V’”' - ^
f.&ii.t •■ ■ ■■:• _ • . .'‘V'_-;' i<-: .;■■-■
■■ ■ •
;*f*
«i.
I?
■
1 Connect the connector to the unit. Hold both edges
of the connector and slide the connector onto the
unit until you hear a click.
2 Unwind and straighten the band. To more easily
straighten the band, slightly bend the tip of the
band in the opposite direction.
3 Hold the body of the unit and attach the
straightened band to your arm. The band will wind
by itself.
4 Tighten the band with the rubber belt.
To remove the arm band from the unit, hold both edges
of the connector and slide the connector as illustrated.
To vary the length of the rubber belt to fit your arm,
move the velcro fastener to the proper position.
' If the rubber belt and wraparound band becomes dirty,
remove the rubber belt from the unit and clean them.
Notes on the arm band--------------------------------
•Avoid bending the wraparound band forcibly in the
opposite direction. It may break.
•The straightened band will wind easily when you touch or
wiggle it. Be sure to treat it carefully.