Troubleshooting, Specifications, There is no sound – Sony CDP-CX270 User Manual
Page 31: The cd does not play, The remote does not function, The player functions incorrectly, Error" appears in the front panel display, Supplied accessories, Troubleshooting specifications, Additional information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Additional Information
Troubleshooting
Specifications
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There is no sound.
■►Check that the player is connected securely.
■►Make sure you operate the amplifier correctly.
The CD does not play.
■►There is no CD in a slot ("-NO DISC-"
appears).
Insert a CD.
■►Tr^ert the CD with the label side facing right.
■►Clean the CD (see page 30).
■►Moisture has condensed inside the player. Press
OPEN and leave the player turned on for about
an hour (see page 30).
The remote does not function.
■►Remove obstacles in the path of the remote and
the player.
■►Point the remote at the remote sensor @ on the
player.
■►Replace all the batteries in the remote with new
ones if they are weak.
■►Set the CD 1 / 2 / 3 switch on the remote
according to the position of the COMMAND
MODE selector displayed in the front panel
display (see page 6).
The player functions incorrectly.
■►The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
reconnect it to the wall outlet to reset the player.
“Error" appears in the front panel display.
■►Consult your nearest Sony dealer.
Compact disc player
Laser
Laser output
Frequency response
Dynamic range
Harmonic distortion
Semiconductor laser
(X
* 780 nm)
Emission duration; continuous
Max 44.6 pW*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
2 Hz to 20 kHz±0.3dB
More than 98 dB
Less than 0.0027%
Outputs
Jack
type
Maximum
output
level
Load impedance
LINE OUT
Phono
jacks
2V
(at 50 kilohms)
Over 10 kilohms
DIGITAL OUT
(OPTICAL)
Optical
output
connector
-18 dBm
Wavelength: 660 nm
MONITOR OUT
Phono
jack
1 Vp-p
75 ohms, unbalanced,
sync negative
General
Power requirements
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
120 V AC, 60 Hz
19 W
When the front cover is closed
430 X 198.5 X 477 mm
(17 x 7 7 / 8 x l 8 7 / 8 in.) ind. projecting
parts
When the front cover is open
430
X
198.5
X
600 mm
(17
X
7 7/8
X
23 5/8 in.) incl. projecting
parts
9.6 kg (21 lbs 2 oz)
Supplied accessories
Audio cord (2 phono plugs - 2 phono plugs) (1)
Video cord (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
CD booklet holders (2)
Label (1)
Design and specifications are subject to change without notice.
31