Sony CDP-C265 - Manual (Page 7)

Playing CDs
Display informatKin while playing a disc
While playing a disc, the display shows the current
disc number, track number, playing time of the track
and the music calendar.
Current disc number Playing time
I d 4 c I
Í )
TRACK
Current track number
SEC I TRACK I I
I . /' /. 5 5 ra
1 2 3 4 5
6 7 8 9 10
Music calendar
The track numbers in the music calendar disappear
after they are played.
Replacing Discs While Playing
a Disc
You can open the disc tray while playing a disc so that
you can check what discs are to be played next and
replace discs without interrupting playback of the
current disc.
EX-CHANGE DISC SKIP
1-------------- !
I'-'t'I'l m
1
---
1
1 1 1 I ' l " ' l
' " 1 ^
ΠD 1 1 1 1 1 I a a
Checking the remaining time
Each time you press TIME while playing a disc, the
display changes as shown in the chart below.
Playing time and
number of the
current track
Remaining time
on the current
track
4 5
o»c iwot
1 f " . 5 6 l " “ l
Press TIME.
V
Press TIME.
V
Remaining time
on the disc
3 3 S 3 4 5
1 1 - 1 . 5 1 l'“l ■
If the track number exceeds 24,
appears instead of the
remaining time.
3 33 3 4 t
1 - H 3 . 3 S l ' " l
This information is available only in
continuous play mode.
n
1
Press EX-CHANGE.
The disc tray op>ens and two disc compartments
apptear. Even if the player is playing a disc, it
doesn't stop playing.
2
Replace discs in the compartments with new ones.
The player plays the disc on the left side
compartment after the current disc, and then the
one on the right side compartment.
3
Press DISC SKIP.
The disc tray turns and other two disc
compartments appear.
4
Replace discs in the compartments with new ones.
5
Press EX-CHANGE.
The disc tray closes.
Notes
• If the playback of the current disc ends while the disc tray is
open, the player stops playing. If the disc is played in
1 DISC repeat mode (see page 9), the current disc starts
playing again.
• In ALL DISCS shuffle mode (see page 9), tracks are
reshuffled on the current disc, while the disc tray is open.
• In program mode (see page 10), only the tracks on the
current disc are played.
• Do not push the disc tray to close it in Step 5, as you may
damage the player.