Selecting the speaker system, Ac hookups, Connecting the ac power cord – Sony STR-DE135 User Manual
Page 7: Caution, Before you use your receiver
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Stripped cords are touching each other due to excessive
removal of insulation
'Q' If you have an additional front speaker system
Connect them to the SPEAKERS B terminals.
Selecting the speaker system
To drive the speakers, select the speaker system as
follows:
To drive
Depress SPEAKERS button
Speaker system A (connected to
the SPEAKERS A terminals)
A
Speaker system B (connected to
the SPEAKERS B terminals)
В
Both speaker systems A and B
(series connection)
A+B
Note
No sound is heard when you press SPEAKERS A+B without
connecting speaker system B.
Where do I go next?
Go on to the next section to connect the AC power cord.
AC Hookups
Connecting the AC power cord
Connect the AC power cord from this receiver and
from your audio/ video components to a wall outlet.
If you connect other audio components to the
SWITCHED AC OUTLET on the receiver, the receiver
can supply power to the connected components so you
can turn on/off the whole system when you turn on/
off the receiver.
SWITCHED AC OUTLET
Caution
Make sure that the power consumption of the component
connected to the receiver's AC outlet does not exceed 120
watts. Do not connect high-wattage electrical home
appliances such as electric irons, tans, or TVs to this outlet.
Where do / go next?
Before you use the receiver, go to the next section to make
sure t f m f nil the controls are set to the appropriate positions
Before You Use Your Receiver
Before turning on the receiver, make sure that you
have:
• Turned VOLUME to the leftmost position (0).
• Selected the appropriate speaker system. (See
"Selecting the speaker system" on this page.)
• Set BALANCE to the center position.
Before you use your receiver for the first time or when
you want to clear the receiver's memory, do the
procedure below:
1/(1) (power)
MUTING
1
2
Turn off the receiver.
Press I/(I) (power) for more than 4 seconds.
"INITIAL" appears in the display and the items
including the following are reset or cleared:
• All preset stations are reset to their factory
settings.
Turn on the receiver and check the following indicator.
• Press MUTING or MUTING on the remote if the
MUTING indicator turns on.