Sony STR-DE135 - Manual (Page 14)

Additional Information
FM tuner sectio n General
Specifications
Tuning range 87.5 - 108.0 MH/ System Timor section: PLL
quartz-kvkod digital
svnthosizor svstom
Audio power specifications
terminals PrL'amplifior section:
Low-noise NF tvpo
POWER OUTPUT AND TOTAL
Intermediate
frequency 10.7 MHz equalizer
Power amplifier section;
HARMONIC DISTORTION
Pure-complomentar\’
Sensitivity Mono: 18.3dBf, 4.5/A' SEPP
With 8-ohm load, both SkTLM: 38.3dBf, 45iiV
channels driven, from 20 -
Usable sensitivity H.2dBf. 2 /fV(IHF)
Power
requirements 120 V AC, 60 Hz
20,000 Hz, rated 100 watts
per channel minimum RMS
S/N Monti: 76 dB Power 155 W
power, with no more than Storco: 70 dB consumption
0.09 % total harmonic
AC outlets 1 switched, total 120 VV
/
distortion from 250
distortion at 1 Storco: 0.5 % lA Max
milliwatts to rated output. kHz
Dimensions 430 X 144 X 306 mm
Separation 45 dB at 1 kHz (17x5'’/8xl2V8
Amplifier section inches)
Frequency 30 Hz- 15 kHz ^dв
Stereo mode (8 ohms at 20 Hz - 20 kHz response Mass (Approx.) 8.1 kg (17 lb 13 oz)
less than 0.09% total
harmonic di.stortion) Selectivity ÓOdBaf 400 kHz Supplied FM wire antenna (1)
lOOW + lOOW accessories AM loop antenna (1)
Remote commander
Frequency TV /SAT, CD, MD / TAPE,
AM tuner section
(remote) (1)
response VIDEO, Tuning range 10 kHz interval* Size AA (R6) batteries (2)
10 Hz-50 kHz ±1 dB 530- 1710 kHz
9 kHz interval Design and specifications are subject to
Inputs 531 - 1710 kHz change without notice.
Sensitivity Impedance S/N
Antenna Loop antenna
CD,
MD/TAPE, ,,,, „ 50
Intermediate 450 kHz
TV/SAT, 150 mV 78 dB
frequency
VIDEO
Usable sensitivity 50 dB/m (at 1,000 kHz)
Outputs MD/TAPE REC OUT:
Voltage: 150 mV,
S/N 54 dB (at 50 mV/m)
Impedance: 10 kilohms
VIDEO AUDIO OUT; Harmonic - 0.5% (50 mV/m,
Voltage: 150 mV,
distortion 400 Hz)
Impedance: 10 kilohms
PHONES: Accepts low Selectivity At 10 kHz: 40 dB
and high impedance At9kHz: 35 dB
headphones
Muting Full mute
BASS BOOST +10 dB at 70 Hz
TONE ±8 dB at 100 Hz and
10 kHz
Tuner Section
FM stereo, FM/AM superheterodyne tuner
You can change the AM tuning interval
between 9 kHz and 10 kHz. After tuning
in any AM station, turn off the receiver.
Hold down the PRESET TUNING +
button and press the l/Cl) (power)
button. All preset stations will be erased
when you change the interval. To reset
the interval, repeat the procedure.