Step 1: select the dss receiver's rf security code, 72 chapter 6: using the setup menu – Sony SAT-A3 User Manual

Page 72

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Setting the Security Code
(SAT-A3 Only)

If the DSS receiver is accepting or receiving signals from another RF
remote control in your home (or from a neighbor's house), you can

eliminate this problem by changing the security codes tor the DSS
receiver and remote control.

Note

As mi alternative, you can eliminate this problem by disabling the RF
capability of the DSS receiver, if yon have no need for RF transmission. See

"Selecting IR/RF Transmission (SAT-A3 Only)" on page 71 for details.

There are two steps to changing the RF security code: Step 1 is
changing the DSS receiver's security code; step 2 is changing the DSS
remote control's security code. Both the receiver and the remote control

'must use the same three-digit security code.

Step 1: Select the DSS Receiver's RF Security Code

Select REMOTE CONTROL from the Setup Menu.

Select RE SECURITY CODE and then select a different security

code.

The DSS receiver and remote control

are shipped with the RF security code

set to 000.

SET UP REMOTE

REMOTE SIGNAL

REMOTE CODES

IR ONLY

RF SECURITY CODE

Select the RF security
code for the DSS
receiver.

CODE 001
CODE 002
CODE 003
CODE 004

▼

CANCEL

IDENTIFY

HELP

Select OK to save your changes and return to the Setup Menu.

Go to "Step 2: Set the DSS Remote Control's RF Security Code" on

page 73 to continue.

72 Chapter 6: Using the Setup Menu

This manual is related to the following products:

SAT-B3