Selecting the impedance, Multi-channel surround setup – Sony STR-DA50ES User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Speaker System Hookup

Selecting the impedance

Set the IMPEDANCE SELECTOR for the speakers as

indicated in the table below. Check the instruction

' manual of your speakers if you’re not sure of the

impedance. (This information is usually printed on a
label on the back of the speaker.)

If the nominal impedance of

Set IMPEDANCE SELECTOR to

your speaker is

Between 4 and 8 ohms

8 ohms or higher

Note

Be sure to connect front speakers with a nominal impedance of 8
ohms or higher if you want to select both sets (A+B) of front
speakers (see page 23).

Multi-Channel Surround
Setup

For the best possible surround sound all speakers should
be the same distance from the listening position (©).
(However, this unit lets you to place the center speaker up
to 1.5 meters closer (©) and the rear speakers up to 15 feet
(4.5 meters) closer (©) to the listening position.
The front speakers can be placed from 3 to 40 feet (1.0 to

Do not place the center or rear speakers farther away from the
listening position than the front speakers.