Compaq 99875320-5 - Manual (Page 30)

USB HID IntelliHead Swipe Reader
DECODE_ENABLE PROPERTY
Property ID:
0x1A
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x00
Description: This property is defined as follows:
Bit
Position
7 6 5 4 3 2 1 0
Decode
Type
Reserved Reserved Reserved Reserved Reserved Reserved Reserved JIS Type 2
When a decode type bit is set to 1 (true), the decode type represented by that bit is
enabled. When a decode type bit is set to 0 (false), the decode type represented
by that bit is disabled. The reserved decode type bits should always be set to zero.
This property is stored in non-volatile memory, so it will persist when the unit is
power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Note
The JIS type 2 decoding option was not added until firmware with software ID
21042812K01 was release in October 2008.
Example Set property Request (Hex):
Cmd Num Data Len Prp ID Prp Value
01 02 1A 01 (enable JIS Type 2
decode type)
Example Set property Response (Hex):
Result Code Data Len Data
00 00
Example Get property Request (Hex):
Cmd Num Data Len Prp ID
00 01 1A
Example Get property Response (Hex):
Result Code Data Len Prp Value
00 01 01
22