Sony STR-GX700ES - Manual (Page 18)

I
Chapter 3 Additional Operations
Recording
This receiver makes audio/video recording and editing easier. Before you get started,
make sure all the AV components are connected properly.
Recording on a Tape, DAT or an MD Recorder Recording from Another Tape (Dubbing)
You can record and make copies of audio program sources
on a tape, DAT or MD using the receiver. See vour tape
deck, DAT deck or MD recorder's instruction manual if you
need help. Tape dubbing is possible only in the directions that are
shown below. Be sure to connect a playback deck to the
DAT/MD IN jacks and a recording deck to the TAPE REC
OUT jacks.
Audio signal flow |
Rotate the FUNCTION knob to select the
recording source.
Set the recording source to be ready for
playback.
For example, tune in the desired station for an FM/
AM broadcast.
Insert a blank tape into the recording deck or
a disc into the MO recorder and adjust the
recording level, if necessary.
4
Start recording on the recording component
and then start playing the recording source.
!f '=> Audio signal flow
Rotate the FUNCTION knob or press TAPE to
select the deck for playback.
Insert the tape you want to record into the
playback deck.
Insert a blank tape into the recording deck.
Adjust the recording level, if necessary.
Start playback on the playback deck. Then
start recording on the recording deck.
Dubbing will start.
You can monitor the sound being recorded on a
tape
If you record on a 3-head tape deck connected to the TAPE
REC OUT jacks, you can monitor the recording results by
connecting it also to the TAPE IN jacks. Press TAPE while
recording or dubbing, until the TAPE MONITOR indicator
lights up. To listen to the source sound, press the button
again until the indicator goes off.
18