CDA RV 700 User Manual
Page 40
40
Fig. 41
Fig. 40
gas pipe
cooker
rear protection
1/2” BSP (male)
Gas connection
Cat: II 2H3+
The gas supply must be connected to the gas inlet which is located at the rear of the
appliance (see figure 40).
If the connection pipe cross the cooker, it must be positioned under the cooker rear
protection.
To screw the connecting tube operate with two spanners (fig. 41).
After connecting to the mains, check that the coupling are correctly sealed,
using soapy solution, but never a flame.
GB