Crestron electronic IM-WCCV - Manual (Page 17)

Crestron IM-WCCV-M iMedia Wall Plate Computer & Video Center
Operation
The IM-WCCV-M can be used to turn a system on or off, select a source, adjust
volume or adjust the microphone level.
Turn on the System Press the PC button to turn on the system with the PC signals routed to the IM
receiver or press the VIDEO button to turn on the system with the video signals
routed to the IM receiver. The associated LED will light to indicate the selected
source.
Select a Source Press the PC button to route PC signals to the IM receiver or press the VIDEO
button to route video signals to the IM receiver. The associated LED will light to
indicate the selected source.
Adjust Volume Turn the volume knob clockwise to raise the volume of the selected input; turn
counterclockwise to lower the volume of the selected input.
Adjust Microphone Level Microphone level is adjusted by holding either the PC button or the VIDEO
button and turning the rotary VOLUME knob, depending on the source that is
currently selected. For example, if the PC source is selected you would need to
hold the PC button while adjusting the VOLUME knob to adjust the microphone.
When the PC button or VIDEO button is released after adjusting the microphone
volume level, the selected source will remain at the volume setting it had prior to
adjustment of the microphone volume.
Control over the source audio volume level is regained by adjusting the
VOLUME knob without holding down either the PC button or the VIDEO
button. The source volume level will gradually ramp up or down to the level set
by the rotary VOLUME knob.
Turn off the System Press and hold the selected source button for five seconds. The source button LED
will flash and then turn off.
Operations & Installation Guide – DOC. 6621A iMedia Wall Plate Computer & Video Center: IM-WCCV-M • 13