Crestron electronic IM-WCCV - Manual (Page 11)

Crestron IM-WCCV-M iMedia Wall Plate Computer & Video Center
PIN WIRE COLORS (EIA 568B)
iMEDIA ASSIGNMENT:RGB,
COMPOSITE AND AUDIO
1 WHITE/ORANGE - RGB RED
2 ORANGE + RGB RED
3 WHITE/GREEN - RGB GREEN
4 BLUE + AUDIO / POWER
5 WHITE/BLUE - AUDIO / POWER
6 GREEN + RGB GREEN
7 WHITE/BROWN - RGB BLUE / COMPOSITE
8 BROWN + RGB BLUE / COMPOSITE
2. For optimum performance, Crestron strongly recommends using CRESCAT-IM cable, available from
Crestron. Other high quality, low skew (15 ns per 100 m maximum) CAT5e/CAT6 wiring may also
be used with varying performance.
3. To determine which is pin 1 on the cable, hold the cable so that the end of the eight pin modular jack
is facing away from you, with the clip down and copper side up. Pin 1 is on the far left.
4. Ensure the unit is properly grounded.
Industry Compliance
As of the date of manufacture, the IM-WCCV-M has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Operations & Installation Guide – DOC. 6621A iMedia Wall Plate Computer & Video Center: IM-WCCV-M • 7