Tri-Tronics Pro Control® G3 - Manual (Page 7)

H. If you are a very long way from the training device, range could be the
problem. (You can use the sound button to confirm that the receiver is getting
your transmitter signal.) Maximize your range by holding the transmitter
straight overhead when you press the button. You can also improve range by
raising the receiver higher off the ground, and by pointing its antenna straight
up or straight down. Never operate a Pro Control
® G3 receiver without an antenna.
I. There may be a malfunction in your training device itself. If you cannot
resolve the problem, contact its manufacturer.
Problem #3. My training device is plugged into the receiver,
but the TEST light does not light.
Be sure the receiver is turned on and its batteries are charged.
The TEST light only lights up while the TEST switch is pressed.
If it is still not lighting, there may be a failure in the wiring of your training device.
Contact the manufacturer of the training device if you can't resolve the problem.
Visit Our Website tritronics.com
To Order tritronics.com • 1-800-456-4343
Product Information, Product Support & Customer Service
[email protected] • 1-800-456-4343
General Business Phone: 520-290-6000 • Fax: 520-722-9000
Write To Us At Tri-Tronics, Inc., P. O. Box 17660 • Tucson, Az 85731
The products in this Owner’s Guide are covered by the following patents:
6170439, D445706, D445707, 6,750,758 and patents pending.
Pro Control ® , Pro Control G3 TM , G2 TM and G3 TM
are registered trademarks of Tri-Tronics, Inc.
‘the standard’
®
T
RI
-T
RONICS, IN
C
.
P
R
O
U
D
LY
MADE IN TH
E
U
S
A