Tri-Tronics Sportsman - Manual (Page 14)

OPERATING THE SPORTSMAN
Before putting the collar on the dog, take a few
moments to practice your timing as you press
the stimulation button.
Activating the Collar. Make sure there are batteries
in both the transmitter and the collar. Activate the
collar by pressing the on/off switch. The red LED
will blink slowly.
Operating the Continuous Mode. Set the upper
rocker switch on the transmitter to C. In continuous
mode (C), stimulation starts when you press the
button and stops when you release it, or about ten
seconds, whichever comes first. Press and hold
the stimulation button.
Both the collar and transmitter LEDs will glow steadily.
After about ten seconds, the transmitter LED turns off
while the collar LED automatically returns to the state
of blinking once per second, even though you are still
holding the stimulation button down. This indicates
that “time-out” has occurred.
Release the stimulation button. Now wait a few moments
and press the stimulation button again. The collar and
transmitter LEDs will begin to glow steadily again.
Operating the Momentary Mode. Set the upper
rocker switch on the transmitter to M. In momentary
mode (M), stimulation starts when you press the
button, and stays on only briefly, regardless of
when you release it.
Now set the lower rocker switch to LO. Press and
hold the stimulation button. The collar LED will
glow briefly, then return to the state of blinking
once per second, even though you are still holding
the stimulation button down. The transmitter LED
will stay on for about 1/2 second.
Operating the Sportsman Page 12