Tri-Tronics Sportsman - Manual (Page 11)

Applying Stimulation. The gray button on the side
of the transmitter is the stimulation button. Press this
button to make the collar deliver electrical stimulation.
Green Indicator Light. This green LED will come on
when the stimulation button is pressed. The time that
it takes to turn off will depend on which mode (C or M)
you’re in. In momentary mode (M) in both HI and LO,
the green LED will turn off after approximately one-half
of a second. In continuous mode (C), the green LED will
turn off when the button is released, or at “time-out”
(about ten seconds), whichever comes first.
If the LED fails to light, or the light emitted is very
dim, it’s time to replace both transmitter batteries.
Belt Clip. The Sportsman is shipped with a belt clip
already attached. Tighten the screw prior to use. To
remove the belt clip, loosen the small screw holding
it in place.
You can slide the strap of the collar through the
transmitter belt clip and buckle it – a convenient
way to keep the transmitter and receiver together
when not storing them in a case.
2-Dog Model. The Sportsman is
available in a 2-dog model. Each
collar responds to a different signal
which is selected by a toggle switch
on the transmitter. The colored
dots above the toggle position
match the colored collar straps.
NOTE: You can select only
one active collar at a time
from the transmitter.
Page 9 Sportsman