beautypg.com

Takata Racing RACE 4 SNAP User Manual

Page 9

background image

17

18

C

AR E AN D

M

AI N T E N AN C E

I

NS PE CTIO N

Inspect the harness belt thoroughly for damage before each use.

Make sure that the inspection of the belt is included with regular check-ups of

the race car and its equipment.

Regularly check correct torque of bolts.

Check for expiration date of the racing harness as it applies to the regulation

of your sanctioning body and/or the FIA or SFI tag, prior to each use.

Never use any belt that is cut, torn or damaged in any way!

Replace it immediately, cut the old belt in half, and discard the old

belt so that it cannot be used again. Cuts, tears and other damage
to the belt will greatly reduce its effectiveness, may cause it to fail,

and may result in severe injuries or death.


C

LE ANI NG

To clean the harness belt, use only mild soap and warm water.

Never use solvents or other cleaning solutions, they can weaken the webbing

or stitch pattern.

Never use chemical solvents or cleaning solutions to clean the rotary buckle.

Do not dry the belt in the sun or near a radiator, in a clothes dryer or with a

hair dryer or with any other mechanical or electrical heating device. Heating
webbing may make the material shrink and the precisely designed elongation
rate will be changed.

Always allows a cleaned belt to air dry naturally.

Always have damaged sub-assemblies of the harness belt replaced before

using the harness belt again.

Never modify, disassemble or repair the belt or hardware components by

yourself.

Never clean your racing harness with chemical solvents or spray

cleaner.

Webbing or buckle housings weakened by solvents or chemicals

may fail during an accident and severe injuries or death may occur.


A

CCI DE NT

Any harness belt which was used during an accident is unfit for further use

and must be replaced.

Never continue to use a harness belt which was in use during an accident.

Replace it immediately.

FIA and other sanctioning bodies require that inspectors cut the racing

harness, or cut the labels off the racing harness, after an accident.

Always inspect all anchorages for damages such as deformations or cracks,

after an accident.

Strictly follow the recommendations of the vehicle or roll cage manufacturer if

a repair should be necessary.

Never re-use a harness belt that has been in an accident of any

type. The belt can fail in a subsequent accident causing serious

injuries or death.








A

D DRE S SES

World-Wide Sales [except North America and Japan]:

SCHROTH Safety Products GmbH
a Takata Corporation Company

P.O. Box 2440
59714 ARNSBERG
GERMANY

Phone:

+49 (0) 2932-9742-0

FAX:

+49 (0) 2932-9742-42

eMail:

[email protected]

www.takataracing.com

North American-Importer:

HMS Motorsport, Ltd.

9A Electronics Avenue
Danvers, MA 01923
USA

Toll Free: (855) 4-TAKATA or (855) 482-5282
Phone:

(978) 406-4116

FAX:

(978) 774-1548

eMail:

[email protected]

www.takataracing.com

This manual is related to the following products: