T&D Machine Products Chrysler B-1 Rocker Arm Assembly with 5/8" diameter rocker shafts User Manual
Page 3
The rocker arm should not be operated with the adjuster screw more than one turn
up or down, from the initial adjuster position. Doing so can cut off the flow of oil to
the rocker arm.
5. FINAL
ASSEMBLY
After all of the stand heights have been set, place a rocker and shaft back on the
stand to assure good rocker to valve alignment and torque the stand attaching bolts
to 50/55 ft-lbs. Install the 5/16 studs and torque them to 50 inch-pounds. When the
stands are aligned and tightened down, place the rocker arm and shaft assemblies
on the stands and tighten the shaft hold down nuts to 25 ft-lbs. After all of the
rockers have been tightened down, set valve lash and torque the adjuster screw
jam nut to 5/20 ft-lbs.