beautypg.com

Transmitter programming – Crimestopper Security Products CS-2002DC SERIES III User Manual

Page 9

background image

TRANSMITTER PROGRAMMING

This system will learn a maximum of 4 transmitters.

1. Turn Ignition ON/OFF…ON/OFF …ON. You should hear (3) chirps.
2. Press the Program/Override Button 5 times and you should hear 5 light flashes and 5 siren chirps.

(System is now in transmitter programming mode.)

3.

Press and release Button #1 on the remote. The siren will chirp once. Press Button #1 AGAIN, you
should hear 2 chirps on the second press for code-learn confirmation. Sometimes it takes a 3

rd

press to

get the remote to learn.

4. Repeat step #3 for up to 3 additional transmitters, or turn Ignition OFF. Siren will chirp 3 times and lights

will flash 3 times when exiting the transmitter programming mode.

Note: If you are using CS-2002DC III identical alarms system in two vehicles, you can program button 4
(PANIC) from YOUR remote to ARM/DISARM the OTHER vehicle’s alarm. Follow steps above at the OTHER
vehicle, except press YOUR remote Button #4 (PANIC) 2 times in step #3 above. The other vehicle’s alarm
will learn YOUR Button #4 (PANIC). You can only ARM/DISARM the second vehicle. You cannot perform
any other special or auxiliary functions on car #2.

DIAGRAM:

IGN

OFF

TURN IGN. ON

3 TIMES:

ON, OFF
ON, OFF
ON.

5 CHIRPS

PRESS

BUTTON

5 TIMES

PRESS LOCK

BUTTON 2 X's

5 FLASHES

(CODE LEARNED)

IGN

OFF

LEARN

ANOTHER

REMOTE

OR

3 CHIRPS

1st = 1 CHIRP

2nd = 2 CHIRPS

PANIC