Scilogex MS-S - Manual (Page 8)

6
MS-(H)-S Analog (Hotplate) Magnetic Stirrer
Items Descriptions
Stir knob
Set the rated rotary speed in the safe
stirring range from 0 to 1500 rpm. The
function “Stirring” is switched ON or
OFF via the knob
Heat knob
(MS-H-S)
Set the rated temperature in the safe
temperature range from room temperature
to 340 ℃. The function “heating” is
switched ON or OFF via the knob.
LED heating Lit when heating
LED Power
When the device is switched ON, the
LED power is lit.
Mains switch Switch ON or OFF.
Table 2
6 Operation
• Put the device on the stable and safe place，ensure the
speed control knob and the temperature control knob to the
lowest position and plug in the mains power.
• Turn ON the power switch.
• Turn the speed control knob regulation to set the rated
rotary speed in the safe speed limit from 0 to 1500 rpm.
• Turn the temperature control knob regulation to set the
rated temperature in the safe limit from 0 to 340℃.(MS-H-S)
• The instrument begins to work.
Note：
Forbid to transfer the vessel when the instrument
working，or you must restart Stir function again,
avoiding Stirring bar breakaway.
7 Faults
• If a unit fault happens, please power down the instrument.
• Switch OFF the unit at the main ON/OFF switch for a few
seconds.
• The stirring function will continue to operate at the speed
set before the fault took place.
• The heating function will continue to operate at the set
point before the fault took place.
• If the problem is not solved, take the unit to your technical
service center.
8 Maintenance and Cleaning
• Proper maintenance can keep instruments working in a
good state and lengthen its lifetime.
• Be careful not spray the cleanser into the instrument when