Schiit Ragnarok - Manual (Page 6)

UNIVERSAL MANAGED AMPLIFIER
+ +
- -
INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5 BALANCED OUTPUT SE OUTPUT
SPEAKER OUTPUT SCH-09K
0A19C2832
115VAC 450W
ITEM
RAGNAROK CONTROLS
2 Input Indicators.
These indicate which
input is selected.
“1” = Input 1,
“2” = Input 2, etc.
If you’re not hearing
anything, make sure
Ragnarok is set at the
right input.
1 Input. Press this
button to cycle
through the inputs.
Ragnarok will
perform a self-check
and the LEDs will
flash every time you
do this. That protects
your equipment, and
is completely normal.
3 Gain. Press this
button to cycle
between three levels
of gain: 1, 5, and
20. Lower gain is
better for sensitive
headphones, and
higher gain is better
for speakers. Use
the one that sounds
the best and gives
you the best range of
volume adjustment.
Ragnarok will perform
a self-check when
gain is switched, and
the LEDs will flash
while this is being
performed.
5 Volume. Turn it up to
increase volume, turn
it down before smoke
comes out of your
headphones or speak-
ers. You’ll hear rapid
clicking inside the
Ragnarok when you
use the volume con-
trol—this is the relay-
switched attenuator.
When you’re switching
gains, it may be a
good idea to turn the
volume knob down, so
you don’t blow up your
headphones or speak-
ers due to a sudden
gain increase.
1 2
4
5 6 7 3
ragnarok owner's manual.indd 6 4/10/14 2:38 PM