Rega RP8 - Manual (Page 10)

9
TTPSU
Connect the turntable power interconnect between the TTPSU and the turntable. Make
sure the PS1 mains transformer is plugged in and connected to the 24V AC input
terminal in the back of the TTPSU. Switch the mains power on. To minimise the risk of
hum pick up by the cartridge, the power supply should be situated as far from the
turntable as the interconnect cable will allow.
Push the power button on the front panel to turn the TTPSU on - When the power supply
is switched on, the Rega logo will illuminate RED, This indicates that 33 rpm is selected.
To activate 45 rpm, press the button again and the Rega logo will illuminate GREEN,
indicating 45 rpm has been selected.
CONNECTION TO THE AMPLIFIER
The tonearm external phono leads must be connected to your amplifier’s phono stage.
Connect as follows : Red right channel / Black left channel. If your amplifier does not
have an integrated phono stage you will require an external stage (sold separately).