Rega RP6 User Manual
Page 10
9
TRANSPORTING YOUR RP6
Should you need to transport your RP6, to avoid any possible transit damage, the following
recommendations must be followed.
Remove tonearm balance weight and secure the arm in its rest with tape or covered wire. This
will ensure no sudden or violent movement is transmitted to the delicate bearings.
Remove platter. When removing, hold down the hub centre at the same time as lifting the platter
on each side.
NEVER place your RP6 upside-down or on its side. This would allow oil in the hub/bearing
assembly to leak and cause speed and or wear problems.
If you have to ship your turntable or use a carrier, save and use ALL of the original packaging.