Qmark I SERIES - Industrial Floor Air Circulator - Manual (Page 2)

HOW TO ORDER REPAIR PARTS
In order to obtain any needed repair or replacement
parts, warranty service or technical information, please
contact Marley Engineered Products Service Center toll-
free by calling 1-800-642-HEAT.
When ordering repair parts, always give the informa-
tion listed as follows:
1. The Part Number
2. The Model Number
3. The Part Description
4. Date of Manufacture
Part No. 5200-2587-001
ECR# 34905
7/01
Dear Customer,
Thank you for your interest in Marley Engineered
Products products. We’re sure you will enjoy its benefits
for many years to come. Please take a minute to fill out
the following information and keep it in your permanent
records.
Date Purchased __________ Date Installed________
Model Number _____________________
LIMITED WARRANTY
This product by Marley Engineered Products is warrant-
ed to be free defects in material and workmanship for 12
months from date of original purchase.
There is no other warranty, express or implied, except
such as is expressly set forth herein.
Seller will not be liable for any general, consequential, or
incidental damages, including without limitation any
damage for loss of use or loss of profits, for any breach
of warranty or for negligence. Seller’s liability and
buyer’s exclusive remedy are limited to the repair of
defective goods or the shipment of equivalent goods, or
the granting of a reasonable allowance on account of
any defects as the seller may elect.
To obtain performance under this warranty, you must:
1. Contact the Marley Engineered Products Service
Department at 1-800-642 HEAT between the hours of
8:30 a.m. and 4:30 p.m. E.S.T. Mon. thru Fri.
2. Provide the model number of the product, the date of
installation, and state the nature of the difficulty being
experienced.
3. The Marley Engineered Products Service
Representative will determine the best way to resolve
the difficulty.
Products within warranty which have been installed and
returned to the seller for repair will be repaired and
returned as used products. Repairs to products outside
the warranty period will be subject to labor and parts
charges.
Some states have enacted legislation which (a) does
not allow the inclusion of limitations on incidental or con-
sequential damages; (b) does not allow limitations on
the length of a warranty period; (c) precludes exclusion,
during the period of a limited warranty, of any implied
warranties of merchantability or fitness for purpose.
To the extent of such provisions being applicable in your
state, the limitations in this warranty may not apply.
TO ENSURE SAFE OPERATION
Be sure that operating instructions (packaged with the
product) are followed and that moving parts are kept
clean and free from obstructions.
Any warranties granted or liabilities assumed hereunder
will not apply to goods that have been damaged in tran-
sit, altered, repaired, installed or operated otherwise
than in conformity with the above requirements for safe
operation.
LIMITED WARRANTY
CARRIAGE BOLT
ACORN NUT
CROSS BRACE
WASHER
WHEEL
LEG
ACORN NUT
WASHER
CARRIAGE
BOLT
NUT
NUT
SPACER
SHOULDER
BOLT
WHEEL
SPACER
SHOULDER
BOLT
FIG. 2
Step 2: Install each shoulder bolt through washer, spacer, wheel
and nut. Then on through flattened end of leg into the axle
brace. Repeat on the other side and tighten securely.
AXLE BRACE
Step 3: Assemble one collar on the top of each leg. Insert the handle with fan
head assembly into the legs through the collar. Tighten all four set
screws. (Adjust height with upper set screws only.)
HANDLE
FAN HEAD
ASSEMBLY
SET
SCREW COLLAR
LEG
470 Beauty Spot Rd. East
Bennettsville, SC 29512 USA