PulseTech SC-12 SuitCase Charger (746X810) - Manual (Page 6)

6 7
will corrode and damage charger.
c) Never allow battery acid to drip on charger when reading electrolyte specific
gravity or filling battery.
d) Do not operate charger in a closed-in area or restrict ventilation in any way.
e) Do not set a battery on top of charger.
13. GROUNDING AND AC POWER CORD CONNECTION INSTRUCTIONS
a) Charger should be grounded to reduce risk of electric shock. Charger is
equipped with an electric cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
b) DANGER – Never alter AC cord or plug provided – if it will not fit outlet, have
proper outlet installed by a qualified electrician. Improper connection can result
in a risk of an electric shock.
c) This battery charger is for use on a circuit having a nominal rating of 110-
240 VAC and is factory-equipped with a specific electric cord and plug to permit
connection to an acceptable electric circuit. Make sure that the charger is
connected to an outlet have the same configuration as the plug. No adapter
should be used with this charger.
14. DC CONNECTION PRECAUTIONS
a) Connect and disconnect dc output clips only after setting charger switch to
the off position and removing ac cord from electric outlet. Never allow clips to
touch each other.
b) Attach clips to battery and chassis as indicated in 15(e), 15(f), 16(b) through
16(d).