PulseTech SC-12 SuitCase Charger (746X810) User Manual

Page 5

h) Use charger for charging a LEAD-ACID battery only. It is not intended to

supply power to a low voltage electrical system other than in a starter-motor

application. Do not use battery charger for charging dry-cell batteries that are

commonly used with home appliances. These batteries may burst and cause

injury to persons and damage to property.

i) NEVER charge a frozen battery.

j) CAUTION WHEN STORING: Pinch/Crush Hazard. Close lid slowly. Ensure

battery cables are properly enclosed within cabinet before closing lid.

11. PREPARING TO CHARGE

a) Remove battery from vehicle to charge. Always remove grounded terminal

from battery first. Make sure all accessories in the vehicle are off, so as not to

cause an arc.

b) Be sure area around battery is well ventilated while battery is being charged.

Gas can be forcefully blown away by using a piece of cardboard or other

nonmetallic material as a fan.

c) Clean battery terminals. Be careful to keep corrosion from coming in contact

with eyes.

d) Add distilled water in each cell until battery acid reaches level specified by

battery manufacturer. This helps purge excessive gas from cells. Do not overfill.

For a battery without cell caps, carefully follow manufacturer’s recharging

instructions.

e) Study all battery manufacturer’s specific precautions such as removing or not

removing cell caps while charging and recommended rates of charge.

f) Determine voltage of battery and make sure it matches the output rating of

the battery charger.

12. CHARGER LOCATION

a) Locate charger as far away from battery as dc cables permit.

b) Never place charger directly above battery being charged; gases from battery