beautypg.com

Pro-Ject Audio Systems Tuner Box S User Manual

Page 5

background image

© Audio Trade GmbH · Pro-Ject Tuner Box S · Revision 2013.1.15

5

Display

A Signal strength meter

B Stereo reception F Mono reception

C Fine tuning meter

D Tuning mode. toggles between the tuning modes

E Tuned frequency

87.90

MANUAL

A

B

C

D

E

Manual program search

Press (approx. 3 seconds) repeatedly until the display shows MANUAL. increases the reception frequency
in 50kHz steps. decreases the reception frequency in 50kHz steps. The tuner is correctly adjusted for a stereo

broadcast when
A the largest number of bars are shown (signal strength meter) and
B two loudspeaker symbols are shown (F one loudspeaker symbol shows mono reception)
C the vertical bar is centred in the fine tuning display

Automatic program search

Press (approx. 3 seconds) repeatedly until the display shows AUTO. starts the automatic frequency scan
upwards, will start it downwards. The maximum signal strength will be adjusted automatically for each
program found.

Program selection from memory

Press (approx. 3 seconds) repeatedly until the display shows MEMORY. will select the program with the
next memory position up the list, selects the program with the next memory position down the list. The

program’s memory position is shown to the right of MEMORY in the display.

Saving a program in the memory list

The memory of the Pro-Ject Tuner Box S can store up to 99 programs. Tune to the frequency of the program

to be stored. Press twice in rapid succession. The display will show STORE. selects the next memory
position up the list, selects the next memory position down the list. Press once on to store the program
at that position. The display shows STORED.

To be able to select a tuning mode (manual program search, automatic program search or

program selection from memory), a antenna has to be conneced.
Saving a program to a particular memory position overwrites any program already stored at that
position. The memory retains its contents through a power off/on cycle.

Replacing batteries

Proceed as follows:

 Unlock and slide open the battery case cover

 Replace the battery.

Make sure the battery is the right way round !

 Close the battery case cover

Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.