Pro-Ject Audio Systems Tuner Box S - Manual (Page 4)

© Audio Trade GmbH · Pro-Ject Tuner Box S · Revision 2013.1.15
4
Auto store function
Long press
0
M4
starts,
0
M1
confirms the auto store function.
0
M1
clears the complete memory while
storing.
0
M2
keeps stations with good signal strength in the memory and overwrites stations with insufficient
signal level while storing.
Front panel controls
Tuner Box S
To switch on from standby or to standby
The push button on the left hand side will toggle the tuner between its fully operational status and standby.
The blue LED above the stand-by push button shows that the unit is switched on. The display shows STANDBY
when the unit is in standby.
If the Tuner Box S is connected to the remote switch-on facility of a Pro-Ject pre amplifier Pre Box S, then
choosing input 1 at the pre amplifier will switch the tuner on. Selecting a different input will switch the tuner off.
Dimming the display, setting the colour of the des display
Press (approx. 3 seconds) to enter the set-up menu.
TUNE
and
TUNE
will change the display brightness. The following settings are available: „display off“,
DIM 1 - DIM 4 and DIM MAX.
0
M3
decreases
0
M6
increases red
0
M4
decreases
0
M7
increases green
0
M5
decreases
0
M8
increases blue
The changes will be shown in the first line of the display. After leaving the set-op menu, the changes will
become valid for the complete display.
0
M1
loads the factory settings for brightness and colour. To leave the set-up menu press
0
OK
.