Pro-Ject Audio Systems Tuner Box S - Manual (Page 3)

© Audio Trade GmbH · Pro-Ject Tuner Box S · Revision 2013.1.15
3
Remote control
ON/OFF INPUT
TUNE TUNE
M1 M2
M3 M4 M5
M8 M7 M6
VOL- VOL+ OK
CH+
CH-
Stand-By
0
ON/OFF
short press turns the unit on, long press takes it back into standby.
Powered on, a short press activates and deactivates mute
Volume
0 _
VOL
and
0
+ VOL
adjust the sound volume
0
INPUT
no function
Selecting the tuning mode
Pressing (min. 3 seconds)
0
OK
selects the tuning modes manual program
search (MANUAL), automatic program search (AUTO) and program selection
from memory (MEMORY) in turns.
Manual program search - the display shows MANUAL
TUNE
decreases,
TUNE
increases the reception frequency in 50kHz steps.
Automatic program search - the display shows AUTO
0
CH-
starts the automatic frequency scan downwards,
0
CH+
starts the scan upwards.
Program selection from memory - the display shows MEMORY
0
M1
-
0
M8
activate the memory function. Pressing
0
M1
-
0
M8
access the presets 1 - 8 directly.
0
CH-
and
0
CH+
select -memory function has to be activated- the memory positions 9 - 99.
Saving a program in the memory list
Tune to the frequency to be stored. Press
0
OK
twice in rapid succession. The display will show STORE.
0
CH+
will select the next memory position up the list,
0
CH-
selects the next memory position down the list.
The memory positions 1 - 8 can be selected directly by pressing
0
M1
-
0
M8
.
Press once again
0
OK
to store the program at that position. The display shows STORED.
Saving a program to a particular memory position overwrites any program already stored at that
position. The memory retains its contents through a power off/on cycle and a power failure.