Pro-Ject Audio Systems Stereo Box DS User Manual

Page 5

Technical specifications Pro-Ject Stereo Box DS

Power output:

2 x 35W/60W at 8 ohms/4 ohms (both channels driven)

Frequency response:

20Hz - 20kHz (-0,1dB, +0,2dB)

Channel separation:

>65dB at 20kHz

Noise floor:

>100dB (A weighted)

THD:

0,1% at 10W

Gain: 33dB
Line-level inputs:

4 pairs RCA/phono sockets

Input sensitivity:

350mV

Input impedance:

100kohms

USB-input:

Mini B socket. USB cable supplied

USB signal:

Digital serial data protocol USB 1.1

D/A converter:

Texas Instruments PCM2706. 16-Bit /48kHz Delta Sigma,

128-times

oversampling

Supported audio format:

PCM (LPCM). No support for formats like Dolby

Digital or DTS

™

Sampling rates:

44,1kHz and 48kHz

Speaker connectors:

4mm  banana plugs, spades connectors or naked wire

Outboard power supply:

24V/5A DC, suitable for your country's mains supply

Power consumption:

5A DC, <1W in standby

Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 72 x 104 (122)mm
Weight:

670g without power supply

Service

Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH

The information was correct at the time of going to
press. The manufacturer reserves the right to make

changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.