CatEye HL-MH310 - Manual (Page 3)

Stadium Light 3
HOW TO MOUNT
Mount the lamp unit to the bracket, the ballast to your frame and bottle
battery to your bottle cage. Then connect the jack of the bottle battery
with the plug of the ballast.
Installing Bracket
1. Attach the bracket to the handlebar using the appropriate rubber pads.
Hand-tighten the bolt.
2. Before tightening the bolts securely, adjust the angle of the beam and
the position of the lamp body. (See “How to Adjust the Angle of Beam”
in the “Important Note”.)
3. Tighten the bolt securely. (For a more secure fit, use a screwdriver.)
Mounting Lamp Unit
Warning !!! Never touch the lamp body until it is thoroughly cooled.
You may get burnt.
• To mount the lamp body, slide it backward onto the bracket until it
clicks into position.
• To remove the lamp body, slide it forward while pushing the lever.
Mounting Ballast
Attach the ballast under the top tube and round the belt. If it is not
secure, use the supporter and stopper as shown in the figure. If your
frame is Y-frame, attach the ballast at the side of the frame.
Note !: Be sure that the ballast is tightly attached to the frame.
Installing Bottle Battery
Insert the bottle battery into your bottle cage. Secure it with the bat-
tery belts.
Note !: The bottle battery might jump out of the bottle cage during
ride. Be sure that it is tightly and firmly fixed.
Connecting Cord
Connect the jack of the bottle battery’s cord and the plug of the ballast’s
cord. Wind the cord round the frame so that it will not hinder riding.
Note: Securely connect the jack to the plug.
HOW TO USE
The continuous run-time is 3 hours from the fully-charged condition.
Note !: When the temperature is very high or low (even within the operating
temperature range), the operation time might become shorter than
the standard time due to the characteristics of the battery.
• To switch on/off, press the yellow button on the ballast. When the light
is on, the GREEN power-indicator turns on.
• After switched on, it takes about 30 seconds for the light to reach its full
brightness.
• Because of the characteristics of the bulb, the beam may flicker or discolor
during operation due to change of the temperature or fluctuation of voltage.
Note !: In case the light does not turn on, switch it off once and wait for
more than 15 seconds; then try again.
After switching off, wait more than 15 seconds until switching on again.
Note !: If the light does not turn on although you have tried several times,
charge the battery.
Note !: In case there are frequent failure when switching on, the bulb
needs to be replaced.
Power Indicator
The light goes off in about 10 minutes after the RED power indicator turns on.
Switch off the light and charge the battery, or use a spare battery.
Note !: The indicator is only an estimation of the battery life.
battery belt
bottle battery
bottle cage
slide
bracket lever
lamp body
ballast
switch
power indicator
rubber pad
bolt
bracket (H-27)
run-time
is 3
hours
stopper
supporter
E