Casio XJ-460 - Manual (Page 6)

6
Projection Operations
Manually Selecting the Input Source
The procedure you should use to select the input source depends on whether you are using
projector keys or remote controller keys.
z To select the input source using projector keys, press the [INPUT] key on the projector to
cycle through input sources in the sequence shown below.
z To select the input source using remote controller keys, press the [RGB/COMPONENT],
[VIDEO], or [S-VIDEO] key on the remote controller to select the input source you want.
The currently selected input source name is shown in the upper right corner of the projection
screen.
z If the currently selected input source is not sending an input signal, the message “No
signal input” appears in place of the input source name.
z Whether the displayed input source name shows [RGB] or [Component] depends on the
current “Input Settings
J RGB Input” (page 42) setting that is configured on the
projector’s setup menu.
ZOOM
RGB VIDEO
AUTO P-IN-P
MUTE FREEZE
S-VIDEO
FOCUS D-ZOOM
VOLUME
[Projector] [Remote Controller]
[INPUT] key
[S-VIDEO] key
[VIDEO] key
[RGB] key
(RGB/Component) (VIDEO) (S-VIDEO)