CDA RC 9000 - Manual (Page 25)

25
Assembling and
dismantling of the side
runner frames
– Fit the side runner frames into the
holes on the side walls inside the
oven (Fig. 22).
– Slide the tray and rack into the run-
ners (Fig. 23).
The rack must be fitted so that the
safety catch, which stops it sliding
out, faces the inside of the oven.
– To dismantle, operate in reverse
order.
Fig. 22
Fig. 23
Inside of oven
The oven should always be cleaned
after use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm
water. Suitable proprietary chemical
cleaners may be used after first consult-
ing with the manufacturers recommen-
dations and testing a small sample of the
oven cavity. Abrasive cleaning agents or
scouring pads/cloths should not be used
on the cavity surface.
NOTE: The manufacturers of this appli-
ance will accept no responsibility for
damage caused by chemical or abrasive
cleaning.
Let the oven cool down and pay spe-
cial attention no to touch the hot
heating elements inside the oven cav-
ity.