Cabletron Systems SWPIM-BRI - Manual (Page 21)

SWPIM-BRI Installation Guide 1-1
CHAPTER 1
INSTALLATION
This chapter covers the following items:
• Unpacking the SWPIM-BRI (Section 1.1)
• Installing the SWPIM-BRI into the host platform (Section 1.2)
• A description of the LANVIEW LED indications (Section 1.3)
• Connecting the SWPIM-BRI to the network (Section 1.4)
• What to do once the SWPIM-BRI is installed (Section 1.5)
1.1 UNPACKING THE SWPIM-BRI
Use static electricity precautions when handling the SWPIM-BRI.
1. Open the packing box and remove the SWPIM-BRI.
2. Attach the antistatic strap (refer to the instructions in the wrist strap
package) before removing the SWPIM-BRI from the antistatic
packaging.
3. Verify that the SWPIM-BRI is undamaged. Refer to Getting Help if
there is any damage to the device. Do not attempt to install the
SWPIM-BRI if it is damaged.
Only qualified personnel should install the SWPIM-BRI.
!
CAUTION
Failure to observe static safety precautions could cause
damage to the SWPIM-BRI. Follow static safety handling rules
and wear the antistatic wrist strap shipped with the
SWPIM-BRI.
!
CAUTION
Do not cut the non-conductive bag to remove the device.
Damage could result from sharp objects contacting the device
or components.